تخمین کور توزیع شده در شبکه های حسگر بی سیم
Abstract
I. Introduction
II. System Model and Problem Formulation
III. Random Transmission Strategy
IV. Statistical Inference Principle
V. Summary of the Blind Estimation Scheme
Authors
Figures
References
Abstract
To realize the Internet of Things, one of the essential elements is wireless sensor networks which can sense the physical conditions of the environment. The ubiquitous sensing is achieved by a large number of spatially dispersed sensors and distributed estimation technology. However, the low-cost sensors are insufficient to support conventional distributed estimation schemes. Since most conventional schemes include channel training process, the resource consumption of which is enormous. Thus, one key challenge in designing a feasible distributed estimation scheme is to reduce resource consumption from channel training. We tackle the challenge by proposing a distributed blind estimation scheme. The proposed scheme consists of two components: random transmission and statistical inference. Specifically, assuming sensors contain only two states that are active and inactive. The random transmission strategy turns the sensing value into a parameter to govern the sensor states. At the fusion center, statistical inference method is used to recover the sensing value. The specific design of the inference method involves the distribution approximation and clustering, which are accomplished by Gaussian mixture model and expectation-maximization principle. By the proposed scheme, the channel information is no longer needed in distributed estimation. Therefore, it is more energy-efficient and more applicable to the complicated wireless environment compared with conventional schemes. Besides, we investigate the impacts of the number of sensors and quantization on the estimation performance. Finally, simulation results demonstrate the effectiveness of the proposed blind estimation scheme.
Introduction
Ubiquitous sensing enabled by wireless sensor networks (WSN) has attracted increasing attention because of its various application areas including environment monitoring [1], health management [2], traffic monitoring [3] and industrial control [4], etc. The WSN develops rapidly since it contains the following advantages: the distributed processing of a large amount of collected information can improve the accuracy of monitoring and reduce the accuracy requirements for a single sensor; the redundant sensors make the system robust; a large number of sensors can increase the coverage of the monitored area. In the various applications, distributed estimation is one of the critical technologies since it can provide accurate estimates of the parameters of the phenomenon [5]. In large WSNs, one factor which affects the distributed estimation performance is the form of the sensor measurements (digital and analog). For the analog approach, the measurements are transmitted directly or via analog modulation to the fusion center (FC). For the digital approach, the sensors quantize the measurements first and then transmit the quantized measurements to the FC.